Whirlpool electric marine space heater problem.? After setting any single handle tap surrounded by the house to medium...
After setting any single handle tap surrounded by the house to medium flow rate and medium heat, when the flow rate is increased to maximum without changing the heat setting the water runs cold. Any help or suggestions appreciated.
I'm just doing soon guessing so here goes: if you turn the hot marine on, does it have the same pressure as the cold? Make sure the hot sea shut off valves below the sinks and at the hot water heater is completely on. Another guess is that it could be possible that something have come thru the hot water line and blocked quantity of the supply line.
There is a heating element surrounded by the water heater which is probably not reaching maximum temp. They do corrode beside age. If the water heater is relatively up to date (less than five years) it probably would be worth replacing the element only. If it is much elder than that it's probably best to replace the entire water heater as the energy expectancy on most water heaters is only going on for 9-10 years anyway. this is just a question did you check it for power .
check for voltage back and after the thermostat
if you have voltage before but not after when cool its your
thermostat if no voltage than its not your hot sea heater
check breaker and line if you return with voltage before and after
it may be the heating thing
Answers: sounds resembling one of your elements has gone bad or conceivably even the t-stat