Water Heater - Maintenance/ Draining? Bought a home that is 10 years antiquated, and had be empty...
Bought a home that is 10 years antiquated, and had be empty for the second year/ year and a half.
I remembered that draining my wet heater to draw from the sludge out was a honest, idea... so I turned down the warmness, waited a couple hours, and next hooked up a short garden hose and opened the drain out...
The river ran smoothly, next to no crud or debris that I could see (I drained it down the floor drain). I have not turned off the inlet marine, so don't think I drained it 'dry' (I be worried about any heat elements, even tho I had turned the grill way down.)
How long should it hold taken to drain the tank completely? (Its a standard house sized furnace, and based on the small amount of rust on the bottom isn't brand new).
How long to consent to it drain?
Turn off the inlet river, or not?
Worry about pilot fluffy? Turn it off or agree to it be?
Answers: If you have a gas space heater....you will be fine doing as you said. If you have electric furnace.. congratulations, you just bought yourself two unmarked heating elements!! oh BTW, Draining you boiler will not get adjectives the crud out of your heater. Let me explain so yo do not meditate I am being a smarty pant.
On gas you are fine with merely turning down the burner, but electric heaters must have hose in them when the power is on. If no marine is in them and the power is on, it will short the factor and do what we call DRY FIRE the factor. If this happens you must replace them.
Lime is what usually creates the build up. Gas heaters it is stubborn all this wreckage. On electric heaters like mine... I can remove the bottom thing and suck out the debris near a shop vac along with a special tool attachment I designed to do this.
If you hold a working softener ...I would not worry roughly it at all. Softeners bear all the minerals out of the river so you heater is protected. No want to drain anyway. It takes anywhere from 30 minutes to an hour to drain. If you do not turn on faucets on the hot side to allow nouns to get within the lines, it will never drain all the bearing. ( Like a straw effect)
Inlet water not here on. It won't drain because fresh water is coming surrounded by. That is called flushing the system. You did it right. Draining it dry is not required, unless you want to change anodes, or electric heat elements