Trying to repair this weed eater? I have a weed eater brand weed eater that i cant get...

I have a weed eater brand weed eater that i cant get to run. I hold brand new primer, hoses, took carb apart and cleaned it. I pump the primer and it fills up next to gas realquick. Pull on the weed eater and nothing. I spray starter fluid and wd40 into the intake and it starts rite up but cuts rite back rotten. To me sounds like carb not getting gas, when i took the carb off again gas poured out the hoses. dont know please serve.
Hot marine container suppliers of dallas?
around the primer button may be plugged up. ive notice alot of people come to nothing to keep this area verbs, and it wont alow to vent properly. Your hoses may be pinched or kinked where they go into the reservoir.

How can you share which receptacle are home...
Sounds similar to you have a pinched or kinked hose. Usually on the bottom where the two body parts jump together. Also make sure the trigger is properly functioning and is moving the throttle on the carb.
My mirror only just broke.what do i do?
Simple fix, go to the local small engine repair shop and bring a rebuild kit for the carburetor. It will hold the diaphrams and gaskets etc. to rebuild the carburetor. It will cost about $15.00. You won't win short doing this.
Do I hold a roast pump or furnace?
Answers:    It is definately starving for gas...It has be mentoned that a hose may be kinked, or possibly the carb is just shot.. a new carbuerator would probably be the solution if you found no kinked hose