Pin hole trickle within copper sea pipe? Is there a expeditious cheap patch? I am totally broke....
Is there a expeditious cheap patch? I am totally broke. I was wondering if near is a plumbing tape or something that can buy me some time.
Thanks
There's a thing metal video you can buy, it looks alot like aluminum foil but going on for two inches wide, that works really ably on something like this. Cut a piece big satisfactory for a couple wraps and take sour some of the backing thesis then dry the nouns as good as possible and after wrap the tape as tightly as you can find it. Once you have a small place covered, you can attach more to get a better stamp.
Get a utility Knife, some Garden hose and a hose clamp. a hose clamp can be gotten at Wal-mart for about $5 usd for an assortment of sizes.
Ciut the garden hose at about 2 inches next to the utility knife and put a slit lenthwise it the hose also. Wrap the hose around the hole (it's better if the hose is on for this, that way you know when you've get it.) Then put the correct size of hose clamp around it. Make sure the Hose clamp goes exactly over the pin hole. You can tighten the clamp plenty so you can move it arround and get it over the hole. Tighten it down and wipe next to a dry towel and look for any leeks. If you have leak re-adjust the clamp and tighten.
Now, pin holes don't usually develop in copper unless here is something wrong. If you dont fix the wrong thing you could own more. It could be a lot of stuff resembling dirt in the lines, it could be poor instalation similar to too much flux on or in the pipe.(If this is the overnight case find a way to flush the smudge with hot sea.) It could be bi-metal conductivity. If you have any other metal bar copperor brass touching the copper it will cause a small electric charge to be created and will eventually lead to a deterioration of the copper.
Answers: USA There is a metal clamp near rubber on the inside that the water utility companies use to repair leak. They fit over the pipe - you do not have to cut the pipe - and bolt up tight. You can seize one at a plumbing supply store. Do not ask Home Depot for advice, they don't own a clue.