Peeling Glossy Paint surrounded by Bathroom? I have a bathroom door that became soiled around the door knob,...
I have a bathroom door that became soiled around the door knob, and scrub it with Windex has cause the paint to loosen up, and peel. It also feels drastically sticky to the touch now. I don't know if the paint on there is grease or latex but it has a rubbery feel to it when it's peel off, so I assume latex.
I sanded it somewhat around the problem spot but cannot get it smooth (still peeling at the edges of where on earth I stop sanding).
Then I tried to go ahead and paint over it with white latex, but it looks pretty unpromising (rough), and stays sticky.
How do I remedy this problem?
the alcohol in your Windex react with the latex paint breaking the paint down eventual the stickiness should go away after just repaint your door
M M could very powerfully be right on with your peeling issue as putting latex over grease is a no no unless it's prepped correctly
I don't know if you can get Nitro-Moors where you live - are you contained by the USA?- but this is THE best paint stripper if you are going to strip and paint the whole door.
Failing that, sand down the area to be painted using a fine grit weekly (250 or 300 grade) and then wash the unbroken door down with sugar soap and rinse with fresh sea on a fluff-free cloth. Allow to dry thoroughly and paint using a gloss roller for a smooth finish.
Answers: It sounds as if latex enamel was used over an oil groundwork paint. The latex is rubber and sits on top of the oil remnant rather than penetrate. When it dries, it shrinks ever so slightly which make the adherence become compromised.
Remove the knob or at least the plate. Try to sand as smooth as possible at the damaged nouns, then use a fine grit sandpaper (400 grit) for the edges. "Rough up, the remainder of the door gently. Apply oil-base primer to the door afterwards finish coats with oil end enamel.
how old is your house? because back within the day everyone used oil latex be hardly ever used.
for the sticky issue id try cleaning it near a lacquer thinner it's the strongest possible thing to use to clean stuff. it should work.
it usually strong to paint over something like a door with a roller or brush because doors and trim are usually sprayed for an even coat.
other things i suggest is pulling as much as the blistering paint as possible because if you paint over it might just bubble and start peeling again. after you could sand the rough edges or even use spackle to even it out. use a putty axe and spread the spackle over the peeled spots then use the putty run through to scrape off the excess. after sand again and paint over it should be "liveable" after that. if it's a big area i suggest using a weenie roller then you wont enjoy all the brush marks.
righteous luck!