My house have ridge vent and gable vent, but no soffits (no where on earth to put them). Should I be off it close to this? I am currently adding insulation surrounded by the attic. The problem with...
I am currently adding insulation surrounded by the attic. The problem with this house is that the roof stops flush against the house walls. There is no agency (that I know of) to install soffits in this situation. I do not own any problems with mold or rime dams. Should I resign from the ventilation alone? Should I conserve cellulose into the eaves since I have no soffits? I see some fluffy coming from the eaves but it is a small amount.
Answers: Alot of builders, roofers and energy gurus are phasing out soffits surrounded by preference of ridge and gable vent, so I wouldn't worry roughly adding soffits--especially since you can't.
Add your insulation, but maintain it a few inches away from the edge so that you can hold on to the air flow undo that is already at hand from the eaves.
I wouldn't jam the celluslose into the corners for the following reason:
1. You don't want to compact celluslose insulation: doing so reduces its usefulness and "shelf life" and
2. "Packing it in" will set it up to act as a moisture sponge from dew and moisture within the air. You don't want a cellulose sponge up within your attic possibly working overtime as a mold factory for the rest of the insulation, studs and framing.
I would put it in clear up to inside a few inches of the walls. Leave 2-3 inches for circulation since you know it's available from the light that you can see coming from the eaves.
Leaving circulation will truly help your insulation to not compact from over the subsequent several years, which would eventually compromise the insulation's effectiveness.
By adjectives means get on insulating your loft right up to the edge where on earth the roof joins the walls, Don't verbs about have no soffits. you will have tolerable ventilation from your existing vent.
Keep Warm!