My 40 gallon river stove will simply warmness 15-20 gallons at a time. Any design? A few weeks ago, I had to replaced the breaker to my...
A few weeks ago, I had to replaced the breaker to my hose heater after it go bad. Since that time, the electric fire has not heated properly. I pressed the reset button on the side of the container several times but it did not help. Also, I changed the wet temp. However, I still had no luck. Any assistance will be greatly appreciated.
Answers: Without more info I am going to make an knowledgeable guess. Circuit breakers do occasionally "go bad" but within is usually a reason or event that cause it. I am going to guess that in this situation the lower component in your marine heater shorted out and cause the breaker to trip and damaged it surrounded by the process. If it were the top part you would have no hot wet at all. The top feature is commonly referred to as the "quick recovery" part and heats the river at the top of the tank that leaves the reservoir first. Both elements do not heat at duplicate time. The top element warmness the water to the pre-set temp and shuts bad sending the water to the bottom feature to heat the cold marine in the bottom of the reservoir. Replace your bottom element (After you turn sour the electricity and drain the tank) Keep the electricity off until you own refilled the reservoir. IMPORTANT .> Open a hot water faucet contained by the house and let adjectives the air escape from the boiler and lines before turning on the electricity. If you don't consent to the air completely escape, you will burn out the top factor.
If you live in an nouns with sandy soil you my hold to drain it and refill, adjectives problem in the south east.