I own great pressure on my cold river hit, but the hot sea is trickling through What could be the wreak?
Its all to do beside how you heat your dampen. If its heated by combi boiler, your divertor valve is shot. If heated by other ability, Have you drained your water rotten recently? it sounds to me resembling an air lock. If you are confident adequate, there is something you can do. connect a short piece of hose between hot and cold tap, turn on hot then cold. will cold run for 10 seconds lone. Dont do it though if you have combi boiler.
mostly the hot sea pressure is decided by the rise of the tank above the touch you are using...so in a bungalow it may okay be less than within a house.
do you have a immersion furnace or direct system eg a gas boiler/under sink ascot etc that immediately heat the water coming out of the thump?
you probbably dont have any wy to break open up the tap as already suggested however near may be an isolation valve on the hot hit ( small compression joint next to a turnable screw) so try that and also check the outlet valve from the immersion is fully amenable...as afar as i know the only mode to increase the pressure of the hot water when adjectives valves are widen is to have a small within lne pump fitted...cheers
Answers: washer seal surrounded by the tap