I enjoy a Kenmore Self Cleaning gas selection Model 665 72002.? I used the cleaning cycle (3 hrs) and now the display wipe reads-...

I used the cleaning cycle (3 hrs) and now the display wipe
reads- E1 F5- locked. How to complete cycle? or disable the lock control?
Why do lights on a dimmer switch run...
Answers:    Your range be built by Whirlpool. Try unplugging the range for 5 minutes. Then plug hindmost in and try the door. It could also be a impossible keypad or stuck button. I have included a relationship for code/fault problems. Just click on the link.

http://www.repairclinic.com/0078.asp#Whi...
How do I stop condensation on my toilet...
rusty their is a bimetal spring that when heated shoves a pin into a lock and you cannot overt the door till the stove cools off.Whirlpool / KitchenAid / Roper
Oven Fault Codes
Ovens next to 4 digit displays
Display Condition Remedy
F0-E0 Analog to Digital failure Disconnect panel for 30 second. if error re-appears then replace control
F1-E1 Defective ERC Replace ERC
F2-E0 Shorted Keypad Replace Keypad
F3-E0 Sensor or Sensor Fuse Open Replace Sensor or Fuse
F3-E1 Shorted lead or Sensor locate short and correct it or replace Sensor
F3-E2 Oven over heat Replace Sensor
F3-E3 Cleaning Temp over steam Replace Sensor
F5-E0 Door Error Check Door
F5-E1 Door Latch Check Latch
F5-E2 Door Switch Check Switch
Ovens with 2 Digit Displays
F0 Defective ERC Replace ERC
F1 Defective ERC Replace ERC
F2 Oven over grill Replace defective Sensor
F3 Oven Sensor Open Check/Replace Sensor
F4 Shorted wire or Sensor locate short and correct it or replace Sensor
F5 Defective ERC Replace ERC
F6 Problem next to time keeping circuit Reset Time or cooking operation and check for proper ground
F7 Shorted or sticking button Clean button or replace ERC
F8 Defective ERC Replace ERC
F9 Door Latch Error Check latch and latch circuit