I enjoy a dryer to be exact 4 line , and the outlet 3 flex any hurried fix? ...
depends what color wires or plate on dryer say 220 next you need run separate string which is code and seperate breaker look at dryer plate
Change the cord on the dryer like this
Changing instruction (3 to 4 prong)
Remove safekeeping plate (usually attached only by 1 or 2 screws)
Remove antediluvian cord and restraint with a mitt or cordless drill. I find that I tend to strip these softer screws near the cordless drill, and they are short enough that they can be smoothly unscrewed by hand. The restraint is the collar that fits tightly around the cord to hold it firm to the dryer.
Connect the center line of the 10/3 cord to the center silver terminal. Turn screw in firmly but not too tight.
Now you own two wires remaining which are attached on either of the two terminal beside the silver terminal. It does not matter which lead goes on which terminal, as both wires are hot. Screw surrounded by firmly.
The hardest part is other the restraint collar. From the outside of the dryer, you need to slide the tab pause of one of the collar halves into the 10/3 cord wire hole. Do alike with the husband of the collar, except on the other side of the hold. The two screws will, abstractly, easily draw the two halves together to tighten against the cord. However, the two halves of the collar never seem to be to be parallel, and it takes slightly a bit of effort to find the screws to block. As long as even the tips of the screws enjoy "caught," you're good to step: turn the screws and they will slowly draw the halves together, even if the halves are not really parallel.
Replace sanctuary plate.
Answers: Not really. Most new 220v appliances enjoy the 4th wire (neutral) surrounded by there for extramural safety. Some appliances even hold a logic circuit built in to them so that they WILL NOT work beside only 3 wires. You are going to obligation to change your outlet and affix an additional indeterminate wire pay for to the main box. Sorry, but that's what you are going to stipulation to do.
Some people might notify you just to hook the ground up to both the indistinct and ground on the new outlet, DON'T DO IT. If your dryer sends any unused voltage vertebrae through the neutral, there's nil but a piece of paper acting as insulation for the cable. Your house could BURN down.