How does freon do as it go through a refrigerant sytsem?

What's the best approach to support a long,...
Answers:    ok the compressor pumps low pressure vapor into the condensing unit where it is condensed rear legs into a liquid then this is lower than pressure because the compressor is constantly pumping more vapor into the condensing unit..this liquid consequently goes through the tubing into the a coil which has a metering device that have a small opening that the pressurized freon is sprayed through into the larger coil tubing. what this does is allows the freon to expand and this enables it to acquire cold and absorb heat fromm the heavens traveling through the a coil. this changes the freon into a low pressure vapor which is again sucked into the compressor and compressed where the cycle starts over.
Garbage Disposal - flywheel seem to work, but...
Inside the system if it is properly charged, some will be a gas, some will be a fluid. when the compressor is turned on it pulls freon from the low side and pushes it into the high pressure side. Any gas gets hot underneath pressure. The heat is reduced in the condenser coil,and become a liquid. It is then pushed through an orifice where on earth it sprays out into the low pressure of the evaporator coil, Then back to the compressor with it's nouns of heat to start the journey adjectives over. I hope you find this helpful.