How can I fix my tub facuet from running? I have 3 knob for the tub, 1 cold water, 2 hot,...
I have 3 knob for the tub, 1 cold water, 2 hot, and the third for the tub/shower. I hold turned off the marine from the well, but, I in a minute need to fix the problem, which is the tub facuet from running. Please be as detailed as possible...feminine doing this....thanks
phone up a plumber
The problem is a leaky washer.
It is usually the cold side which goes first, as cold river has more dissolved solids within it.
What you should do is lift the top of the cold knob rotten. You may need to grip it slightly strongly and wiggle it, but it should eventually come rotten and you will have a thin-ish knob which turns gone and right to turn the tap on and stale, and below that will be either a knurled grip or a nut that you can loosen next to a pair of pliers or the appropriate sized spanner.
Loosen this until the cold slap unit comes away from the prevalent faucet body. You should find a small copper washer (a thin disc of metal near a hole in the middle) underneath. This is the source of the problem - it should trademark the faucet when you close the tap, but due to over tightening or wear and rip they can become thin, perverted, or corroded.
You'll need to draw from a replacement washer from a hardware store - get a couple within case you want to repeat the procedure for the hot tap.
Reassembly is basically the reverse of the above.
This should see you right - good luck!
Answers: resourcefully to your question of your tub faucet leak does your spout run when taking a shower if so you will need to remove the middle module of the handle rotten to get to the screw mounting the knob then you will want a stem socket (tool remover) you may perches from your local hardware store. consequently remove remember lefty loosy righty tighty. If your tub faucet has a drip you will have need of to shut water of to your house remove both middle parts rotten your handles remove screw and remove handles next with your tool mentioned above remove both stems you may any take both stems to hardware store to replace untried (by taking them with you to store you will know how to match up) or you may remove the screw holding the rubber washer on and replace you also may own to replace the seat inside the shower body you will also may enjoy to buy a seat remover tool any further question? please contact me for further details.