Hot wet boiler furnace? I asked this question once already, but I guess I didn't administer...
I asked this question once already, but I guess I didn't administer enough info, so I am going to try this again. Bare near me because I honestly don't know anything about this, that is to say why I'm trying to get info on here. I am currently looking at buying a house i.e. heated with a boiler furnace. There are underneath board vents through out the house, and multiple thermostats to control the heat in the different "zones" of the house. I'm not sure if this also controls the hot marine, or if there is a seperate hot wet heater. My caring is that there are lines that run along the groundwork boards, hot water runs through them and some how heat the house?!?! Like I said, I really don't know, and I am just trying to win a better understanding of this system. ANY info on them would be much appriciated, such as cost to replace them, repair them, or service them. Common problems to monitor out for, how they opperate, and if it would be better than a regular furnace.
Answers: I can't tell from your description whether your system is hot sea or steam. Usually, with baseboard radiators, it is hot dampen which means you do not hold a "boiler", just a hot hose furnace. It is heated by burning either inherent gas or oil.
The baseboard unit "radiate" the heat carried by the hose into the room. Each baseboard should have isolation valve and a small vent (operated by a key). You should bleed any air out of respectively radiator by opening the vent allowing any nouns to escape until water comes out of the vent. Start on the lower floors and work your passageway up to the upper floors of the house. Bleeding the air will maximize the helpfulness.
If you don't get wet out, the system needs to enjoy water added. Look for a supply tap near the electric fire.
This heating system may or may not enjoy a separate water electric fire for non-heating purposes (bath, laundry, kitchen etc.).
Take a trip to your basement and seize familiar beside system. Get your gas or oil supplier or a plumber to meander you through the piping and valves.
Definitely worth getting a reputable heat tech to familiarize you near the system and check it out to see how old it is, how resourcefully it is running, how clean.
They can be expensive to replace, a few years ago I remunerated about $5,000, but it be an emergency installation when it died in the middle of the winter. If you do have need of to replace it you can shop around for a much more efficient system. My direction, don't ignore it, and be okay aware of what is going on with it. It is money economically spent to perform preservation on a heating system.
My furnace heat my hot water as all right, but I hear it is more efficient to own an auxillary water reservoir. They are super insulated and do not call upon the furnace as much to save the water up to temp.