Help electrical system a switched outlet? A switched outlet (only one of 2 switched) stopped working, so I...
A switched outlet (only one of 2 switched) stopped working, so I took it apart to see if there is a rope loose.
The recepticle has places for 5 wires (2 black, 2 white, 1 grnd) Should adjectives of these wires be connected to the recepticle? I ask this because the diagrams I see online have lone 3 wires shown...and i have 4.
In a middle-of-the-road recept wiring setup, you would hold a white, black and probably a bare copper line as a ground, (although it could be green). The white wire would walk to the silver screw, the black wire should shift to the brass colored screw and the bare, (copper), lead to the green screw. That will make both recepts hot when something is plugged within.
However, if one of the recepts is to be switched, then in that will be wires to both recepts and the little brass tab that normally connects the two recepts will enjoy been broken out. If you are thinking of replacing this on your own, be sure to break stale the little tabs on both sides, otherwise you'll own a dead short when you turn on the switch.
Yes, you should have 5 wires connected. Two for the upper (unswitched) outet, two for the lower (switched) outlet and one to the ground.
Bert
Answers: You are looking at a contained by line receptacle. One set of black and white wires will progress on the top of the receptacle. and the other set is for the leads going to the subsequent receptacle or switch the bottom set. Remember that the gold screw are for the hot side and the silver screws are for the independent wires. And the ground has its own nouns to connect to. Best of luck and turn off the breaker up to that time attempting this fix.