Gas wall electric fire motor stopped working and be replaced next to similar to motor...? for 20 years this heater would come on and the blower motor...
for 20 years this heater would come on and the blower motor would blow out the bake only one speed. Apparantly it be a 2 speed motor and now when it comes on, it one and only stays on the slow speed, then get too hot and turns off. I never have 2 speeds before they replaced the motor...can you bypass the slow speed soundly and just put it to the soaring speed to blow out the hot air and heat up the house or it there another switch that wants to be replaced?
Answers: if the switch is a two stage heater sw, it should work fine. It can be wired wrong and still work. But if you want to coppers it, you would have to turn the power past its sell-by date and then you should own a white a black and a copper.
The copper is the ground, it hooks to green or to copper wires only.
the black is the hot leg of the AC power, it should be to the switch on one side and the two legs for power to the lover on the other side of this switch.
The white should be hooked to the other white of teh fan.
If the service man put the power supply, black rope from the power to the same side as a switch the you own only one speed to the supporter. if you turn the switch you have a past its sell-by date fan.
write me if you entail any more help next to it.
johnmccall2@hotmail.com
Furnaces and heaters have to blow at a slower speed to preserve from cooling the air too much. If you rig it to blow fater, it'll with the sole purpose blow cold air. Sounds similar to you need to replace your put a ceiling on switch.