Does anyone know the best method to attatch wooden floorboards to an existing ashphelt floor?
Answers: IF you mean flooring as within toungued and grooved it may be possible to make it a floating floor which is method sometimes used beside hard wood floors. You will requirement to use a membrain foam underlay lots of different types available.
Then gum your flooring boards together without fixing them down to the sub floor, you may involve to devise a method to cramp the boards together as you proceed. ideally the floor should not touch the walls leave 12mm aperture for movement and allow the underlay to nouns up the wall and trim back on completion. when you hold finished the floor you then cover the aperture with the skirting boards. If the room is a vault the the ashfelt may continue up the wall to counter dampness so check this out as you may need to stick the skirtings on or risk destoying your wetness membrain. good luck.
near is a particular type of bonding agent that you can buy at any hardware store but its pricey 100 bucks a pop. nailing wood to concrete is not fine you will either miss and not stir into concrete at all or you will split up the flooring. trying to put anything else under is gonna make happen your floors to bow over time.