Dishwasher from Hell!? We just finished a monthlong kitchen renovation yesterday and we installed a...

We just finished a monthlong kitchen renovation yesterday and we installed a dishwasher. It worked just fine yesterday on the first and second loads we did, and we followed adjectives directions. I went to start a load this morning (we're moving everything pay for into the kitchen and it all has to be washed) and followed the directions and set it to a middle-of-the-road wash with warmth dry. It's a Kitchenaid if it matters. The Jetdry dispenser was full (according to the gauge) and I put one of those little Electrasol powerball blobs within the right compartment. When I went to take the dishes out after it go through the entire cycle and flashed "CLEAN", I found everything was stone dry and the tablet blob thing be just sitting on the bottom of the dishwasher. I cleaned it out and reloaded everything and tried again, and the same article happened. What's going on and how can I fix this?
For some purpose you are not getting water to the dishwasher. Typically the dishwasher is connected to the hot water outlet.

Maybe the marine pump has quit? Trash has built up within the water line?

Your detergent have nothing to do with the problem.
I think it is the electrasol tab. I would try using the other kind that are gel packs. I also notice that if I used the washer or someone took a shower at the same time that maybe within wasn't enough water pressure for mine to verbs well. Also if you have a intricate time with hard hose down spots, try Lemi-Shine! It works great and even keeps the inside of your dishwasher clean. You can purchase it at Wal-mart! Start it again, and put a cup or bowl on the upper rack facing upwards. Open the door after 10 minutes and see if there's marine in the dish. If so, the problem is probably with the Electrasol.

If there's no sea in the dish, it probably will need some more work -- pinched waterline is one possibility.
Answers:    Use only powder. The tab tend to do that. Also check your load settings and make sure if it say heavy load, that you own everything set for a heavy load. Also don't block the river jet inside
Did you reconnect the river?

Return it.