Copper hose pipes leach at the seam, how do I fix it? I don't weld and there is a copper hose down pipe...
I don't weld and there is a copper hose down pipe in the subterranean vault that has a ooze at the seam. I would like to fix the bleed before I re insulate the pipes. Any concept of how to fix it??
There is no unforced way, no alternatives. You shouldn't attempt soldering overhead, in close proximity wood if you've never done it. However, if you buy some fittings and a propane torch kit (probably have everything you need for $20) plus lead-free solder, you could practice. Well worthwhile. Best if someone can school you how--maybe a how-to video on the net? Its not that tough once you catch on, but I wouldn't try a physical pipe until you're more familiar. A massively useful skill, I'm sure you already aspiration you had it.
Also bring back some pipe clamps (copper, with copper nails) for a few dollars. It sounds similar to your pipe is not supported properly.
It can be tough very soon that there is sea in the pipe. You will hold to eliminate the marine in the pipe by draining that nouns. Then, open the faucet it feed to releave the pressure you will create during soldering. Now that that is consummate, you will have to resolder the pipe.
If adjectives this sounds confusing, and you don't know how to properly solder, I suggest you bring in a professional to do the employment. It isn't a difficult fix, but it does take some skill and experience to properly solder a copper pipe.
Answers: You need to shut the wet off within that line first....hopefully that doesn't be a sign of turning it off to the entire house. But at any rate, its a pretty simple fix, if you enjoy enough room around the pipe to maneuver a map gas bottle. (you can bring that at any hardware store). You need to grill up the pipe enough that it will unfreeze flux. (again, any hardware store and it comes in a small tube or small container, along beside solder). Once you can melt the solder onto the pipe in need actually putting the flame to the solder, the pipe is hot satisfactory. But first, melt the flux over the bleak seam, then agree to the ambient heat from the hot pipe liquefy the solder over the bad seam. Kind of tricky getting the solder to stay because it will run while contained by the molten state but you can do it with rather patience. The flux help give the solder something more to bond to. Hope this be some help.