An behind the times drill desires a unsullied cord...? can I replace the cord? not sure what brand it is but...
can I replace the cord?
not sure what brand it is but it's an older corded drill near heavy housing held together beside screws, is within something special I'm missing or can I just unscrew, attach fresh wires from the new cord, and hold at it?
while we're on it, what kind of cord (length, appraise etc), where to acquire it? THANKS folks.
Actually, drills used to own a metal housing, which required a three pronged grounding plug, the newer models, made from plastic don't require a three prong grounding plug, so they were equipped beside the 2 prong polarized type.
If the drill is so antiquated that it has a two cable cord with a two prong plug this scheme the housing is not insulated and has the potential to become an electrical see. For safety's sake it would be best to discard the drill.
Otherwise, if the drill has a grounded (three prong) cord and plug, it should be impartially simple to replace.
When taking the housing apart you will need to take care not to displace the rotor, motor bushings and brushes.
Any quality hardware store should be capable of supply a replacement cord and plug of comparable gauge (probably 12) and length.
When attaching the contemporary cord it is critical to connect the hot (black), neutral (white) and ground wires contained by the correct locations. Make sure you identify these clearly before removing the infirm cord.
This is a fairly simple errand, but if you are at all unsure, I would not attempt it. Electricity is nil to be guessing with.
Answers: Yes sir, just unscrew it, if the wires are soldered use a solder iron to untangle the connections, get another cord and solder it pay for together. If it's wire nutted later just nut it hindmost together. Write down what color wire go where. (On both ends of the cord)