Bumpy lawns? I have awfully uneven and bumpy lawns. I use a rotary...
I have awfully uneven and bumpy lawns. I use a rotary mower on them and I believe that short having a flipside roller on the mower this is causing me most of my problems. The wheel just ride up the furrowed turf. I am thinking of purchasing a push mower with a roller on the stern. Do you know if this will help me. I am thinking of top dressing the lawns . Thank you for reading this.
Hire a garden roller, the one on the back of a mower have insufficient weight. You can unhurriedly fill the dips and pull off a level meadow in time. Feeding is earth-shattering regardless of the uneven state.
There may be several reasons for a bumpy meadow. These are a few:
-frost heave over several years.
-subsidence over septic cistern drain field lines.
-tunnels made by moles or gophers
Whatever the create you should start by filling within the lower areas with a sandy soil to bring everything to an even rank. Water to settle, and spread more soil in any remaining low spot. Then reseed if needed, though if your grass is rizhomatous it may sprout through the infill. Once you enjoy leveled your lawn a roller on the subsidise of your mower will likely prevent adjectives problems.
Answers: Rent a sward thatcher, it's not expensive. Thatch the lawn later top dress it with fine sand. Overseed the sand and roll out peat moss resting on that.
I assume you meant the actuall grassland is thick and askew not the soil under it. But the sand will stratum out everything regardless. Using soil ontop of lawns is ok, but grass will pop up through sand quicker.
Hire a garden roller and use if when the lawn is wettish - the mud will move easier.
When I have this problem I took the soil from the high bits and used it to crowd the low bits. Worked really well. Cut an 'H' shape over the large bit, fold back the two flaps (up and down) and remove some soil. Fold the flaps stern. Do the same shape next to a low bit and fill the hole to the required rank, then fold the flaps support.
Top dressing with a sandy soil is the mode to go. A roller won't own any effect unless it's really big and heavy, competent to bridge the undulations.
Do it in stages if you want to preserve looks contained by the interim. Try to get it on evenly and next spread it over the ground with a straight frame (lute). A short length of plank fixed to a broom handle will do.
All a mower roller does is bequeath a level setting for the adjectives edge, whether it's a rotary or cylinder type... and can distribute you nice looking stripes too