We enjoy a raw wood floor within our home, I would love to rob the mat up and move about fund to a automatic flooring I was wondering if anyone could afford me some advice on the...
I was wondering if anyone could afford me some advice on the best mode to prepare and stain the wood also does it need seal in between the wood?
Answers: If the finish is within good shape, adjectives you will need to do is clean up the floors and take up the tack strips around the brim. If the wood is unfinished or even worse the finish is messed up you will enjoy to refinish the floors.
To begin you rent a floor sander from somewhere close to Home Depot. Make sure you get different grades of sandpaper for the sander. Also fashion sure you rent the hand sander for the edges.
You nick off the quarter round adjectives around the walls and sand the floors starting with the course sandpaper and working your road to the finest sandpaper.
It is important that you follow the directions that come with the sanders and any directions given to you by the clerk at the rental store. Read the directions formerly you leave the store and bring in sure you understand how to use the machines.
Only sand beside the grain.
Clean up the mess as you jump and tape bad the rooms you are not refinishing so the fine dust will not settle everywhere else.
When the floor is fully sanded you hold several choices for refinishing.
You can use a oil type polyurethane any with or in need stain included.
You can use a tung oil type finish.
You can even paint the floor if you yearning.
When you are ready to finish the floor dance to the paint department and examine all the different types of finishes available. The general public in the department should be capable of help you choose a finish type and pass you directions for application.
You will need to stamp the floor in some route because if you don't seal the floor and spill something on it, the mess won't come up.
if the floor [panels are nail, dont forget to sink them lower with a punch until that time sanding, save the sander from ripping on the high points.