My gas dryer broke. Everything works the instrument it should except that the warmness turns rotten after 10 minutes.? I checked all the electrical parts next to a vol-ohm meter...
I checked all the electrical parts next to a vol-ohm meter and they work.
What else there could be wrong?
Answers: It almost sounds similar to a high-limit is tripping. A high-limit is a type of thermostat that will shut down the heat if the dryer get too hot.
Typically the dryer gets too hot if the dryer is not properly vent. I concur with the first answer: check your dryer vent from the nouns at the dryer all the opening to the outside vent and clean it out. Also verbs out your dryer filter. If you use fabric sheets, they can tend to clog up the lint filter (see connect below). Just wash the lint filter beside warm soapy river to clean up the dryer sheet residue if needed.
If your dryer's burner runs and make heat for ten solid minutes since shutting off, that's probably commonplace. These things don't heat constantly for the full time the dryer is running, it would bring so hot it would melt something. There are thermostats located surrounded by the air ducts that sense the amount of bake and moisture and will adjust the time of "flame on" to keep the proper temp. It will as a rule cycle off and on several times during a complete drying time. And for the rest of you that think you know adjectives about dryers, you should know that if the elevated limit thermostat blows, it doesn't reset, it's basically done. No more heat time of year. It has to be replaced, along beside the operating thermo that allowed the overheated condition in the first place.