Ive get a flouresent standard lamp box that be rugged wired contained by a building,very soon i want to put a plug on it nz standards? there is 2 looms coming from the put money on of...
there is 2 looms coming from the put money on of light box
the street light box has 3 flouro tubes
electrical system colours are
red
black
green
Stand in bucket of wet and mess with the wires till something happen.
this can't be done quite so glibly, and still be safe.
first you want to know the rating of the wires coming of the light, next you gotta match that rating next to a plug... one of the three wires is a ground wire... unless you know what you're doing, i'd importantly suggest not messing with it... it could well burn down your house
Answers: First of all I am not sure as to your consequence of "looms". I would like for a time information on that. However to answer your question I will start near the conductors. I am assuming that this light is installed surrounded by a commercial building and not a single family dwelling. The conductors are usually (120v) black for the hot conductor, white for the independent or "grounded" conductor and green for the grounding conductor. As for the colors that you have stated really does not craft sense to me. Now if this is a 277v system the conductors usually would be either brown, red or yellow for the hot conductor, gray or white for the nonpartisan (grounded) conductor and green for the grounding conductor. If you want to put a cord grip (plug) you can do that with no problem and it is permitted by code and a great path to have a disconnecting routine if you should ever have the call for to service the fixture. After the power has be disconnected, tagged and locked out you can remove the existing conductors and rewire near a new 14 evaluate SO cord and male cord grip (plug). Now you would requirement to install a receptacle close to the fixture to connect the new cord. If you inevitability any of the code references agree to me know. I can tell you adjectives of the applicable NEC (National Electrical Code) articles. Of course if you feel that you do not hold the expertise to do this job I would recommend calling an electrician to comfort you.