How to conversion gasket on refrigerator door next to the freezer on top?
Answers: Peel back the gasket and along the edge are tiny screw, you need to take them out and verbs the door well before you put on the hot one,tape newspaper over the debut of the freezer to keep warm nouns from entering and make sure you have a biddable game plan, have somebody time you and who ever is closest to how long it take wins a beer from the looser.
ok i've done this job at most minuscule 100 times so i know the ropes first the job is the same for the freezer or frig
unseal the door and roll back the gasket exposing the screws that hold the retainer bar these usually are 1/4 inch speed screws do yourself a favor and go to the hardware store and go and get a 1/4 inch speed wrench it makes the job much easier immediately that you have exposed the screws loosen respectively one but don't remove them! with the screws loose verbs outwards on the gasket till it's bead comes out from under the retainers
after bathing the gasket for a few minutes in hot river to soften it hold it in place and working from 1 point push the rounded bead contained by behind the raised lip of the brackets as you work your road around the door snug every second or third screw to keep the gasket in place, you may find you necessitate to use a flat bladed screwdriver to push the bead in place especially around the corners when the gasket bead is completely in place swing the door to the closed position if it appears to be abnormal ,tight at the top and open at the bottom or vis-a versa because the screws are single snug you can twist on the door and get the gasket facade to line up on top and bottom, when it looks even gently embark on the door and tighten down the screws checking it's fit after every few screws once it's tight close the door, if the fascinating seal is not contacting the frame in a place or two obtain a hairdrier and on high, heat the gasket till it softens up satisfactory to expand to the frame when you have the gasket installed use duct tape to hold the door shut tight fo a light of day or so and it will seat itself