Front door that keep freezing shut ..how can i stop it? we have changed out the door ...we are fixing to correct out...
we have changed out the door ...we are fixing to correct out the locks cause we have to destroy them to bring out of the house.
i am thinking it is a lack of insulation within wells surrounding the door... is within anything i can do to fix it til spring??? i am in alaska and it is -17 right presently????
Find out what it is that freezes.
If it's the lock that freezes, consider that it has metal parts exposed on the outside. Perhaps somewhat insulation, like plastic foam, tape over it with ducktape, may save it warm adequate.
If it's possible to take the lock out, do it. Dry it thouroughly and fully, later lubricate it.
Other parts that freeze, like the door to the frame, might be overcome by rubber insulation strips (DIY store), which you lubricate next to silicone grease/ or silicone oil.
Install a storm door. Will keep some boil in and some moisture out.
Do not recommend the use of WD40. It is a petroleum product that leaves a sticky asphalt residue in locks and make them not work properly. Use a silicone spray only on locks! Even graphite is foolish as it gunk's up and eventually makes lock inoperative.
WD40 on door jamb/insulation could be adjectives but silicone is better.
Answers: One way to check and see where on earth the cold is coming would be to pull stale the casing trim around the door and slowly move a lighter around the edges of the door. There will be adequate cold air coming within to make the flame flicker. If it's coming surrounded by between the door slab and the jamb you are in stipulation of weatherseal or an adjustment to help the door close tighter. If it's coming surrounded by between the jamb and the framing use a spray foam to seal that nouns. Do not overfill with the spray foam though as it will bow your door jamb and kind it difficult to close the door. If you don't have nouns coming in, you don't see apparent frost, then run near mgerben's plan for checking the lock.
wd40, loads of it. look for a spray lube next to a high viscosity, it will stick to adjectives metal parts and stay greasey to really low temperatures. wd40 first to remove moisture.