Ebony stain how much to apply? I am staining a pine fish tank hutch and I am using...
I am staining a pine fish tank hutch and I am using an ebony stain. I own applied about 3 coats and when it dries it looks close to a purple black. Do I need to hold reapplying until I achieve black or will it run black with the laquer?
Thank You
I had impossible to tell apart experience with "black" stain...fundamentally that it wasn't particularly black. I completed up using India ink. When this question come up in another forum, someone have a suggestion for a specific ink: "Design Higgins WaterProof Drawing Ink 4415". You would probably have to find an art supply store to carry it. Another option that have been mentioned is black leather dye. Whatever you want to try, try to test it on a bit piece of pine or an area that will not usually be see.
To realize a black lacquer look you paint it black then coat it beside clear lacquer , the more coats the deeper the gloss look.
You may be capable of have the stain darkened at the paint store but staining pine will pause up being lighter than if you be staining a naturally dark wood. Three coats and the wood is probably sealed and won't adopt any more stain.
Good luck
Dan
Answers: Well in that are a few different types of stain. One is solid body, which might be a purple black depending on who maked it. The other is a wiping stain which I mull over you have. In this overnight case you wet a napkin or brush, apply it, then wipe it stale. Each coat you apply and wipe off will carry alittle darker. Make sure the stain it completely dry between coats. Here's a boo boo I give attention to you did before you started...YOU NEED TO REALLY MIX IT WELL. Good luck.