Do I bear apart furniture to refinish it? I have 6 dinindg room chairs that wishes refinishing and are rickety....
I have 6 dinindg room chairs that wishes refinishing and are rickety. Should I start by taking them apart and then start sand the pieces? I thought it might be good to verbs out all the holes that are fitted next to wooden dowels as there is like mad of carpenter's glue build up from heaps "fixes" over the years. Also, do I sand it bare? On one piece there is detailed carving so I don't contemplate I can sand that - how do I deal near that?
yes take them apart, i use Forbes's paint stripper,
but most will work, don,t sand in recent times strip them
when you put them back to together use gorilla bonding agent,
This is woodworking. Is also Upholstery.
If they are Heirlooms or Antiques, you could very smoothly ruin them.
Sanding may cause more sprain than a stripper would.
Many varnish strippers can be used safely. Also use wet, lots of water surrounded by between the stripper or varnish removal steps.
It takes time and self-control to properly refinish quality work.
If you are doing the chairs, do the table also, or it will look amazingly funny.
The dowels may have to be replaced, re-drilled, refitted, or anything to make the correct again.
Sanding is one of the worst things that you can do to antiques, it can be done, use a soft small piece paper.Is never recommened or looked on as fitting work.
Have Fun
Answers: Yes, you need to bear them apart, clean out the excess bonding agent from the joints and reassemble. For the holes, I use the plumber's copper pipe brushes, available for a couple of dollars and surrounded by a variety of sizes. I'd recommend buying tentative dowel pins. Continued, potentially bad, repairs will fashion the problem a bit more difficult but not insurmountable. But new gum will not stick to old bonding agent, with a few exceptions (hide epoxy resin, for example). If you need to, you can insert some little slips of veneer to tighten up the joint.
For removing the finish, sanding is now and then the best solution. Use a chemical stripper, scrape past its sell-by date the goo, rinse it, let it dry, and later do a light sand.
Label and number every piece at least once. That agency, you will be able to achieve back together the right opening. Chairs are notorious for have pieces that vary by basically a little bit, and you don't want to put a piece surrounded by upside down or backwards.
If they are coming apart - disassmble then verbs out the joints past re-assembling. make sure you cramp them up nice and tight (or use a windlass - ie. tightened cord). the strip them when they are assembled - that path you will et any suplus glue stale, and refinish. I wouldn't sand it bare - you'll lose adjectives the orginal filler, but back to an even overall colour befor reappying your varnish. Use Nitromors or varnish stripper near a toothbrush on the carved areas, and neutralise in accordance near the directions.