Do I call for to sand douglas fir deck in the past seal? I just purchased some enormously smooth douglas fir 1" by 4"...
I just purchased some enormously smooth douglas fir 1" by 4" deck stock from the lumber yard and am wondering if I involve to sand it with a fine position sandpaper before applying a sealer, or whether I can merely apply the sealer to the wood as is. A second question is whether I own to apply a stain after sealing the wood (and, if so, whether I necessitate to sand the sealed wood prior to applying the stain!).
Many types of lumber come from the mill near a bit of glaze on them. I would recommend sand with a 120 grit sandpaper which will allow the sealer or stain to hang to the wood. If it's too smooth, you won't get any permeation. If you intend to stain the wood, you would do that first, and then stamp it. Hope this helps.
it would help alot if you sand the wood first.
get a vibratory sander and start next to 60 grit sand paper. be in motion over the wood with the crumb a few times and then use 100 grit sand broadsheet. do the same entry as before near the 60 grit, and then switch to 220 sand weekly and that should be good plenty to knock down any slivers or bug a boos that might hurt someones foot.
then you can proceed to apply the wood sealer
R
O
S
C
O ROSCooooooooooooooooooooooooooooooooooo
Answers: Ok here is the operation, How smooth is your deck right now? If its smooth plenty for you just engender sure its clean and afterwards seal it. As far as stain go if you decide to stain you do it since you seal. If you stain you may enjoy to sand lightly previously you seal. It depends on the stain.Oil base stains don't raise the particle so no sand, water plinth stains do raise the pellet so you must sand. I wouldn't think contained by my opinion that Douglas fir requirements to be stained. Good luck