Best course to build an 8x16 shed short lend a hand? I was originally planning to build each outside wall next put them...
I was originally planning to build each outside wall next put them onto the concrete slab with the help of one girl, but after realize that each wall is going to be like 300 lbs or more, I'm wondering if its a upright idea to build it in its position? By that I miserable, place the bottom plate in its permanent spot, after put in 3 or 4 king studs and the top plate on top. Then just trying to slide adjectives the other studs in between. I've never done this without building it lying flat, and not sure if it cause problems doing it this way (especially since you can only pin diagonally into the bottome plate).
build your walls laying flat and then a short time ago hoist the walls up they will be alot lighter that way and you can still do this yourself.Good Luck! build the walls on the flat, leave the out side covering sour, then lift it into place, [less weight]
Even on the 16' wall you and her should be capable of raise it. Just get one train started then the other by putting a saw horse or such under it final and forth. Once half way up respectively can get a hand effortless. Have the board to brace it and such handy.
rd
Answers: Whenever you can build a wall on the ground and tilt it into place that's what you should do. There isn't anything drastically wrong with building a wall in place and toe-nailing it to the bottom plate. I hold built many gable end walls this track.But... if you can avoid it... Fill a cooler with some of your friends favorite drinks and call a couple of them over!
If you must build it contained by place I would recommend marking your layout and nailing the king studs, trimmers, headers and conceivably the corner studs through the bottom plate and first top plate and then raising the wall. As long as you don't hold too many doors and windows (I don't create in your mind you do in a shed) the wall should be light adequate for you to lift. As another said, use a kicker to keep the bottom plate from sliding. There are several options for raising the wall: conceivably it will be light enough for you to heave: you can cut 2X4 braces and attach them to the top plate with gate hinge and nail some blocks to the floor; as you lift the wall the braces slide along the floor and once chronological the blocks you can have some 'resting' places. The safest options for raise the wall by yourself are the winch mentioned in another answer if you own a tree or something else to use. There is also a device I have only hear called a wall jack you can rent. It's kind of close to a very tall off-road Jeep jack. Attach it to the floor and the top of the wall and crank it on up. You inevitability to use one every several feet depending on how heavy the wall is.
Once you own the wall up go ahead and slide the common studs within place and nail them through the top plate then toe-nail them to the bottom plate.
It is difficult to build a wall surrounded by place, but certainly not impossible. The biggest problem you will have is trying to hold everything within place while trying to nail the studs in place.
I would recommend build the wall lying flat and amount out a way to raise the wall.
One remedy would be to place a kicker (anything that will stop the bottom plate from sliding past the point you want it) and then using a rope and come-along attached to a truck/tree/other strong reason and raise the wall using mechanical force.
I enjoy done similar things when putting up SIP (Structurally Insulated Panel) walls, except using a crane rather than a come-along.