What paint technique for faux adobe walls? I am doing my livingroom Spanish style (not Mexico - Spain). ...
I am doing my livingroom Spanish style (not Mexico - Spain). After researching I can only find hugely few colors they used on the walls. Ocre is mainly outdoor but be also used on the interior and of course Adobe. I only just hate have plain white walls so I am hoping to use a brownish color on the walls and whitewash with white. Does anyone hold any experience with this? I could use the support I've never done this technique. I also dont know if maybe a different technique would better mimic adobe walls.
Thanks !
Answers: One article you might do before sculpture is to texture the walls so that they look like adobe.
You'll obligation to get a box of drywall mud (comes contained by a 50 pound box), a stucco brush, a 6-inch spackle knife, a bucket to delicate out the mud, and a drywall sanding eyeshade (optional). Also, make sure to carry lots of dropcloths, because this is a very messy procedure.
Scoop some mud into the bucket and dilute it next to water until its the consistency of stirred mayonaise (not so much that it's runny, but satisfactory that you can scoop it up beside the stucco brush). Take a brush full of mud and fling it at the wall. It should stick to the wall and not run down the wall. If it's too runny, scrape it rotten with the spackle axe, put it back into the bucket, and append more mud to thicken it.
Fling the mud at the wall to cover it, but not completely. The mud will be the high points of the texture and where on earth there is no mud will be the low point. When the wall is covered, tolerate it sit and dry for about 15 minutes.
Lightly drag the spackle axe across the blobs of mud to flatten them. Go in different directions within different areas of the wall so as not to create a definite template. When you're done, let it dry for a couple of days. After it's dry, you can insubstantially sand it with a drywall sand screen to smooth out rough edges or merely leave it rough. If you sand it, brush it past its sell-by date with a soft broom to remove the dust. Prime and paint.
It's really profusely easier than it sounds, once you get the droop of how to do the splattering of mud and the knockdown (flattening) technique. And, it really gives a great adobe-like texture.
i would paint a platform coat of ocre first. after its dried completely. do a color wash using a completely thin reddish/brown lacquer . after that is dried , dry brush greatly lightly over adjectives walls with an sour white.
try your techniques first on posterboard until you gain the colors and finish that you are happy beside.