What largeness do we put the wainscoting? We are redecorating our bedroom and would resembling to do wainscoting....
We are redecorating our bedroom and would resembling to do wainscoting. Does it have to be at bench level? I would giving of like it to be high to give it a more dramatic look. Is nearby a rule at which height it should be?
within is no specific rule,,, but it is better to figure where on earth the middle of the wall is and then bring to the fore the waines coating just a bit better...
eye it and see where abouts you resembling it.
There is no set dimension for this. Here are the things I rob a close look at.
#1. Height of window sills contained by the room.
#2. Height of electrical switches in the room
We hold installed this from as low as 32" to as high as 42".
I don't approaching to bring it up so high the wall switches want cut into the wainscoting. Also think in the region of how you plan to cap it rotten on the top, and what thickness this capmold or chairail will be. I similar to to install a flat pc. of frame the same mass as the wainscoting behind the top slither of the chair banister or cap molding. That agency the chair guardrail or cap molding can be placed over the top 1" or so of the wainscoting which make for an easy installation. Remember if you are on a budget, if you gross your wainscot 32" or less - you can seize 3 pc. out of a sheet of paneling. I only just put up bead board wainscot in our dining room. Ran it up to 42", which come up past sill on fanlight windows. I removed the apron beneath the window, the side cover and installed the bead board panels. Need for a moment custom notch on the shield, replaced the apron trim under the sill, installed the baseboard and it worked out great.
Answers: If it's too elevated it might be overdone but it all depends on what you put surrounded by that room and what color the top part will be on the walls:
http://www.homedesignersoftware.com/user... http://farm3.static.flickr.com/2212/1861...
http://img.timeinc.net/aolhome/i/design/...
http://images.lowes.com/general/w/wainsc...
To take a more dramatic look ~ I really like the subtle stripes above it near one of the paint colors having sort of a shimmer to them:
http://www.peppel.com/PowderRoom/DSCN017...
http://farm1.static.flickr.com/43/838600...
http://farm3.static.flickr.com/2046/2052...
http://farm1.static.flickr.com/39/813368...
Or you could use it as a frame banister - you know the top part that sticks out a touch more so you can put small objects and/or picture frames on it.
This one is good for decide among the different types:
http://faq.elitecrownmoldings.com/wainsc...
other ideas:
http://farm3.static.flickr.com/2395/1857...
http://farm3.static.flickr.com/2308/1858...
http://farm3.static.flickr.com/2030/1857...
There are no rules and it truly depends on what you are doing above the separation.
Chair level is probably a angelic starting point. However, if your treatment above the separation is bold, you might want to experiment with lowering the separation point.
Depends on the room, if a porthole was 36" illustrious , then the wainscot would be probably 33". It is generally not difficult than about 3 foot.
The original theory was to protect the wall from tiny dirty hand, as it could be washed sour.
When a chair is against a wall, nearby is a real possibility that the top will splodge a wall, wainscot prevented this.