I only just ripped my mat rotten my stairs. Their is fitting wood underneath but unwanted paste from the mat? how can i get this glue rotten the wood? any advice, tips,...
how can i get this glue rotten the wood? any advice, tips, methods?
the glue have to be scraped of in big chunks, but also take diligence not to gouge the wood, try not to make huge scratches on the wood
...consequently an electric sander will be helpful to sand off the residue, that soaked into the wood and cause the coloration differences..resist using the sander until you scrape off at most minuscule most of the glue cause the gum will gum-up the sanding pads, belts, etc and cost $$ to use more belts, or pad, disks, etc
.and after the wood is sanded, then it wants to be swpet, vaccumed or swept, and then wiped next to a 'tack-cloth' to pick up the left-over tiny particles that cause bubbles surrounded by the finish coats
...one cleaned, you are free to either re-stain the wood a color, or just apply a durable finish, such as polyurethane.which is also hose proof
...applying several coats of the finish will provide a thick protective surface
...using a very exceedingly very very fine wet'dry 500+ grit sand rag between coats, sand in straight lines with the small piece lines of the wood...the finer the paper the better, really you're only trying to do buffing, and polishing smooth contained by between each coat (not really sanding)ok? (so donot use rough paper)
..after each coat is good-n-dry, 24-48hrs surrounded by normal room temperatures, will support to smooth out the bubbles that rise up..the paper will create a white scratchy look at first but wipe it off next to the tack cloth and apply the next coat.it will go away and look approaching new
Use a heating gun first to loosen the glue, next scrape off beside a spatula. Make sure to get a heating gun near a spatula attachment, you just fit it over the nozzle of the heating gun. Then sand the wood next to an orbital sander and by hand with fine sand daily to get into corners and small areas. After that you can stain and varnish the wood. You can get cement removers at your local Home Depot of Menards, but you'll still have to sand down the stairs and refinish. Use coarse, then milieu, then fine, then extra fine sandpaper (in that order) to distribute it a smooth finish. Then once sanded, if it's a stained floor, re-stain first. Either way, afterwards varnish with 3 coats of polyurithane varnish or polyacrylic varnish depending on which type of stain you use. Seek personnel when purchasing the stain.
http://www.ehow.com/how_2331370_get-glue... Try Goof-Off or Oops from a paint store
if its just the gum alone get a rough sandpaper that will withstand the abuse and sand it bad. or i would suggest buying some wood stripper to remove the crud. paint thinner could do the trick, but be careful with it. Boiling hose down, sand paper, stay away from chemicals
Want easy points? It's only an opinion:
http://answers.yahoo.com/question/index;...
Answers: We just go through the same situation. As hard as we tried (Goo-Be-Gone, fine steal wood or sand tabloid, even liquid fabric softener) nil worked or gave us a polished finish. Once everything was removed (staples, hearth rug backing and glue) we found the finish didn¡¯t match surrounded by places, wear on the primary traffic areas and if something was spilt on the carpet, it gone a watermark. We wasted a lot of time and money , and contained by the end we had to sand the stairs down and hold them refinished. It all comes down to are you happy beside the look of the stairs once you are finished. No? You¡¯ll then have to sand down the stairs. Remember if you sand too much within one spot you are going to have waves within your wood. Staining stairs will not be that difficult (it¡®s not like you have to pour a immense amount of stain then quickly spread it resembling you do when refinishing floor). You may have to apply several coats of stain to obtain the color you want, afterwards add a coat or two of polyurethane to give your wood protection. If you stir ahead with your project, ask yourself, can I afford to loose the stairs for three to four days? Don't forget the smell alone will probably be enough to run you out of your home. If you enjoy children in your home they don't need to be breathing surrounded by that chemical smell.