How do you paint things shiny comment on? shine like saloon paint but how?
shine like saloon paint but how?
Answers: I use oil base high interpret paints. First of all I sand the surface using three different sand papers, starting beside the most coarse and working my way to the finest. I wipe it verbs with methylated spirits because it dries instantly and nearby is no water to gross the timber swell or affect the paint in any channel. I apply a good characteristic undercoat, usually oil base. If you can find a ridge filler undercoat, it will help even out flaws. If you enjoy large pits or dents you might want to saturate with an appropriate filler. Leave for a minimum of 12 hours and sand beside a fine grade thesis. Wipe off beside metho again. Feel with your fingers - if you can be aware of bumps you will be able to see them, so you may necessitate to sand a little more.
For the paint: use the best feature brush you can afford. Ask for advice surrounded by the paint store if you are unsure. Load your brush with a small amount of paint. If it's a small item you should know how to do a stroke the full length in one turn. If not, you will need to reload mid stroke. Apply the paint, reload and pick up where on earth you left past its sell-by date. When one length is complete, go spinal column and lay off within the opposite direction, that is to say to brush the paint all contained by the same direction. Work smartly. When you have completed your first coat, give up your job to dry for a minimum of 12 hours and repeat the sand and paint process again. I usually do three coats of oil base paint, but you may not need to. If I'm doing a clear finish on a timber project, I will rub boiled linseed grease into the clear finish with a vastly, very fine steel wool. It give a lovely soft finish.
There are also two pack products available which can be sprayed on and give a highly high interpret finish, but I have never used those.
Get some high-ranking gloss paint or polyurethane.